|
DESIGN,
DEVELOPMENT, & MANUFACTURE OF COIN OPERATED AMUSEMENT DEVICES
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
NOTICE!
THIS ROM CARD HAS BEEN DISCONTINUED AS OF JANUARY 1999!
|
|
The
CLEARING RAM process has been greatly
simplified via FLOPPY DRIVE, so the procedure described below only
applies to your product if it has NO FLOPPY DRIVE underneath the
motherboard. If you are using DISCONTINUED ROM CARD, it plugs into
the PROM SLOT on motherboard. (SEE: MOTHERBOARD
DIAGRAM).
|
| CLEAR RAM ON DISCONTINUED ROM CARD: |
| 1. Turn off power to the game (power off). |
| 2. Remove the top shunt (small black jumper) located above U28 (see ROM-CARD DIAGRAM below). |
| 3. With shunt removed, power the game back on (power on). The game may or may not power up all the way. Either case is fine. |
| 4. Turn power back off. |
| 5. Replace and put the shunt back in its original position. |
| 6. Power the game back up. "MEMORY CORRUPTED" should now be displayed if you have successfully cleared SRAM. |
| 7. Press test switch inside cabinet and you are finished. |
 |
|
Click
on Image for Larger Picture
|
|
NOTE:
On rare occasions, memory may not clear with only one shunt removed.
If "MEMORY CORRUPTED" is not displayed,
repeat this procedure with all three top shunts removed.
|
|
P
& E Technologies
|
|
5140
West Hurley Pond Road
|
|
Farmingdale,
NJ 07727
|
|
Telephone:
(732) 751-1515 or
(800) 979-9801 |
|
Fax: (732) 751-1015
|
|
Contact
us::
|
